Once the device is powered up it will enter self configuration mode.

When the update counter reaches “100%” the device will automatically restart.

In the “Firmware Update” dialog box select “Yes” to start the update.

Download the ***.bin file from (You may need to create an account, if you didn’t create it earlier) and copy to your microSD Card - root directory.

It is important not to use additional source of power during firmware update! In the event of a power failure during an update the device may crash corrupting its system files and will need to be sent back to the ATN factory for service. To update the new firmware you will need a microSD Card and batteries that are fully charged.

To receive the notification of new firmware updates, please register your device on our website (you’ll receive an email letting you when new firmware becomes available). If you are going to record video then microSD Card should be of Class 10 (10 MB/sec) or faster and have capacity from 4 to 64 GB.īefore operating your device please update the firmware to the latest version. When it pops up a few millimeters, it can be pulled with your fingers or tweezers. To remove the microSD Card from the slot, push it in using the same thin object. There is only one correct direction to insert the microSD Card.ĭo not force the card into the slot as it may damage both the scope and the card itself.

Return the cap into the housing (screw clockwise until finger tight).

To lock when inserting card in the slot, push it with a thin object (a small coin, paper clip, toothpick, etc.).

A new card should be formatted before using.

Make sure that the device is turned off before inserting the card into the slot. To open the cap you should unscrew it counterclockwise. You can find them under the cap on the right side of the device (we marked the cap with appropriate icons).

The device is equipped with microSD Card, microUSB and microHDMI ports. Make sure that the device is turned off before changing source of energy (batteries or USB in power supply mode) Return the battery cap into the housing (screw clockwise until finger tight)ĭo not over tighten as it will be difficult to remove the next time you replace batteries.

Remove the battery cap by unscrewing it counter clockwise.

They will provide much longer battery life. We highly recommend using lithium AA batteries. The OTS-HD will operate on four AA-type batteries. If any accessories are missing or broken contact ATN’s Customer Service.

Ensure that all optical surfaces are clean and ready for use.

Inspect the device for damage to optical surfaces, body, eyecups, operation buttons, etc.

Open packaging box, remove OTS-HD and check the content.

The following steps must be accomplished prior to each mission where the device is used: Download this manual (.PDF, 1.79 Mb) Unpacking

Atn 2000 firmware